Enable graphical adapter without monitor

DVI, HDMI (or lack of), VGA (or lack of), supported displays
Post Reply
SalmR
Posts: 2
Joined: Wed Jan 26, 2011 6:17 am

Enable graphical adapter without monitor

Post by SalmR »

I am using a couple of fit-PC2's. These are stationed somewhere on serveral sites and I am using them as a logger. There is no monitor attached to them, but I need to control the pc's from my office. I am using teamviewer to operate the pc's.

When I start the pc without a monitor attached, the graphical adapter is not started/enabled and teamviewer does not show a screen. I found a virtual display manager, but resolution is too low.

How do I enable the graphical adapter when there is no monitor attached to it. Is it possible to make a pin connection so the computer is thinking there is a monitor attached.

I hope there is an answer to this.

best regards
Rob van der Salm

irads
Site Admin
Posts: 2365
Joined: Mon Mar 16, 2009 2:11 pm

Re: Enable graphical adapter without monitor

Post by irads »

Please specify the OS (WinXP I guess? if so - check http://fit-pc2.com/forum/viewtopic.php?f=36&t=1781)
-------------------------
Irad Stavi
Forum admin

-------------------------

SalmR
Posts: 2
Joined: Wed Jan 26, 2011 6:17 am

Re: Enable graphical adapter without monitor

Post by SalmR »

Dear Irad,

I am using the XP version. I have tried to use your suggestion, but without any luck. I would like to use a MIMO usb/lcd screen with the pc, but it doesn't work when the graphical adapter is disabled. Any suggestions?
irads wrote:Please specify the OS (WinXP I guess? if so - check http://fit-pc2.com/forum/viewtopic.php?f=36&t=1781)

irads
Site Admin
Posts: 2365
Joined: Mon Mar 16, 2009 2:11 pm

Re: Enable graphical adapter without monitor

Post by irads »

We are not experienced with USB displays. There are some discussions on the forum about it, and to the best of my knowledge users succeeded operating them with the IEGD driver.
-------------------------
Irad Stavi
Forum admin

-------------------------

candy123
Posts: 3
Joined: Thu Feb 24, 2011 10:41 am

Re: Enable graphical adapter without monitor

Post by candy123 »

This topic let me learn more information.Thanks for your discuss

Post Reply

Return to “Display interface”