it would be good to adapt the fit pc2 to bad condition ...
Posted: Wed Aug 19, 2009 8:53 pm
I think that the main interest of this very small pc is that we can carry it easily everywhere. So it would be a good improvement if it could be used in very bad situations : dust, rain, ...
I hope that the next version of fit pc will be waterproof. I think the connectors should be fixed on the case instead to be solder on the mainboard ... and be waterproof. It would allow at the same time to improve the protection of the main parts against the mecanical shocks.
Beside this the I think the look would be better if the coners of the case would be more round.
I hope that the next version of fit pc will be waterproof. I think the connectors should be fixed on the case instead to be solder on the mainboard ... and be waterproof. It would allow at the same time to improve the protection of the main parts against the mecanical shocks.
Beside this the I think the look would be better if the coners of the case would be more round.