Page 1 of 1
How can I control GPIOs and I2C?
Posted: Fri May 28, 2010 1:31 pm
by mbc28
Hello,
The fit-pc2 specifications says there is a connector with some GPIOs and I2C. How can I control them? Are there any drivers?
Thank you.
Re: How can I control GPIOs and I2C?
Posted: Fri May 28, 2010 11:26 pm
by irads
This is not supported with fit-PC2.
For commercial project check
www.compulab.co.il for embedded alternatives.
Re: How can I control GPIOs and I2C?
Posted: Thu Jun 10, 2010 6:32 pm
by mbc28
Hi,
I've seen that in compulab website there are 2 alternatives, SBC-FITPC2 and CM-iAM + SBC-iAM.
SBC-FITPC2 has I2C and GPIOs available? or only CM-iAM has them available?
Thank you.
Re: How can I control GPIOs and I2C?
Posted: Fri Jun 11, 2010 3:41 pm
by irads
This forum cannot be used for supporting CompuLab embedded products.
Please contact CompuLab -
sales@compulab.co.il