Page 1 of 1
Boot without periferals
Posted: Thu Sep 24, 2009 10:41 am
by Sandro
Please I need to know if there is the possibility to boot the fit-PC2 without monitor, keyboard and mouse connected. I did not find this possibility in Bios.
Re: Boot without periferals
Posted: Thu Sep 24, 2009 2:44 pm
by MSX
it should work normally without periferals, you don't need to touch anything in the BIOS
Re: Boot without periferals
Posted: Mon Sep 28, 2009 8:16 am
by Steffel
The only issue is that without a monitor attached the fit-pc2 boots under Windows XP with a resolution of 1024x768. I'm running my fit-pc2 without peripherals, controlled by TightVNC.
Re: Boot without periferals
Posted: Mon Sep 28, 2009 1:39 pm
by Ryelands
This
was an issue with the Fit-PC2 but it was resolved by a new driver. Go to:
http://www.fit-pc2.com/forum/viewtopic.php?f=36&t=601
download the "no detect" driver and follow Irad's procedure near the end of the thread. You need a local monitor for initial set up but otherwise it's just fine.
HTH
Dave