New fit-PC2 IR device question
Posted: Tue Feb 02, 2010 10:21 am
Hi I am setting up my fit-PC2 and have a few problems with the IR device.
fit-PC2 with 1.6 Ghz processor
Windows 7 Home Premium
Samsung 500GB hard disk
Built-in WiFi card
I installed the IR drivers for Windows 7 found on this site together with the EventGhost program and added the fit-PC service as instructed.
I would now like to set it up so that I can use a basic universal remote control (in my case it is called Remotec Remote Master 200) to control mainly Windows Media Center (WMC).
I have read all the EventGhost instructions and checked out their website and have to say that I find the process very confusing. There does not seem to be any "macros" for WMC and I am not sure I want to spend the time to become an EventGhost expert to write my own.
Any pointers or suggestions are most welcome.
fit-PC2 with 1.6 Ghz processor
Windows 7 Home Premium
Samsung 500GB hard disk
Built-in WiFi card
I installed the IR drivers for Windows 7 found on this site together with the EventGhost program and added the fit-PC service as instructed.
I would now like to set it up so that I can use a basic universal remote control (in my case it is called Remotec Remote Master 200) to control mainly Windows Media Center (WMC).
I have read all the EventGhost instructions and checked out their website and have to say that I find the process very confusing. There does not seem to be any "macros" for WMC and I am not sure I want to spend the time to become an EventGhost expert to write my own.
Any pointers or suggestions are most welcome.