Enable graphical adapter without monitor
Posted: Wed Jan 26, 2011 6:27 am
I am using a couple of fit-PC2's. These are stationed somewhere on serveral sites and I am using them as a logger. There is no monitor attached to them, but I need to control the pc's from my office. I am using teamviewer to operate the pc's.
When I start the pc without a monitor attached, the graphical adapter is not started/enabled and teamviewer does not show a screen. I found a virtual display manager, but resolution is too low.
How do I enable the graphical adapter when there is no monitor attached to it. Is it possible to make a pin connection so the computer is thinking there is a monitor attached.
I hope there is an answer to this.
best regards
Rob van der Salm
When I start the pc without a monitor attached, the graphical adapter is not started/enabled and teamviewer does not show a screen. I found a virtual display manager, but resolution is too low.
How do I enable the graphical adapter when there is no monitor attached to it. Is it possible to make a pin connection so the computer is thinking there is a monitor attached.
I hope there is an answer to this.
best regards
Rob van der Salm