Two sticks

programmable multi-color LED that plugs into a USB port
Post Reply
Posts: 1
Joined: Thu Jul 25, 2019 9:10 am

Two sticks

Post by keldnorman »

I have two fit-statUSB in one USB hub and adresses them via the

sudo stty -F /dev/ttyACM0 115200 raw -echo -echoe -echok -echoctl -echoke ; echo "#E1D200" > /dev/ttyACM0

But I am not getting fast color changes and sometimes #FF0000 turns the usb GREEN and not RED !? Is there any "reset" command one can send to the stick so it behaves correctly ?

I found that sending "F0" to it makes it shift colors fast but the yellow color is .. not really yellow - it looks like green and you can clearly see the top of the USB is green and the bottom half red - is this normal ? (se picture where i used screen /dev/ttyACM0, then pressed H and then #FFFF00 )
fit-ststUSB programmed to show #FFFF00
fit-ststUSB programmed to show #FFFF00
yellow.JPG (664.77 KiB) Viewed 8315 times

Site Admin
Posts: 419
Joined: Mon Dec 25, 2017 4:21 pm

Re: Two sticks

Post by tamir »

The usage instructions for the fit-statUSB can be found at:

As for resetting the configuration, setting a simple color should override previous configuration.

If the color behavior seems strange or malfunction, you may return the product.

Post Reply

Return to “fit-statUSB”