Bios Settings for USB Boot

Post Reply
schling
Posts: 9
Joined: Fri Jul 12, 2013 11:24 pm

Bios Settings for USB Boot

Post by schling »

Hello,

I am going nuts trying to figure out how to boot from USB in order to install Windows 10 from a pen drive on my FItlet2. The drive I am using is a SanDisk Cruzer Edge and I have checked on an older Lenovo ThinkPad that is boots correctly into the installation screen.

So far what I have done is to:
- Set CSM Support to enabled (to avoid being stuck forever in the BIOS screen)
- Set SanDisk (the BIOS seems to recognise the drive) as Boot Option #1
- Enable Fast Boot and USB Support to Full Initial

The version is 2.18.1263 Copyright C 2017 American Megatrends Inc

Thanks for any help

Robert

tamir
Site Admin
Posts: 419
Joined: Mon Dec 25, 2017 4:21 pm

Re: Bios Settings for USB Boot

Post by tamir »

Please check the following BIOS config:
Chipset -> South Bridge -> OS Selection
Should be on [Windows]

See if that works

schling
Posts: 9
Joined: Fri Jul 12, 2013 11:24 pm

Re: Bios Settings for USB Boot

Post by schling »

Thanks .... it was already on Windows and I just get a black screen after the Compulab Filtlet2 splash screen.

schling
Posts: 9
Joined: Fri Jul 12, 2013 11:24 pm

Re: Bios Settings for USB Boot

Post by schling »

For the benefit of others: I was trying to install Windows 10 32bit and discovered that this is not possible in UEFI mode. Had no problems with 64bit.

Post Reply

Return to “fitlet2 software”