fit-IoT Users Forum

1. Press ME_RST for 3 sec
2. Press RTC_RST for 3 sec

Done. But problem still exists.

Unfortunately there is still a loop with harddisk in. I think the BIOS is still in the configuration state of windows fast boot. All I want is to reset the board to factory defaults. But the RTC_RST does not change these settings. I read about similar problems on other hardware. A solution might be ...

Dear hwmartin, thanks again. Here my answers: Again, I would recommend that you install the memory that shipped with the IPC2 and try the instructions on CompuLab's IPC2 troubleshooting page. I bought the IPC2 without memory and HD. I have tried all troubleshooting steps on the troubleshooting page ...

Dear hwmartin, Thanks a lot for your feedback. Yesterday I bought a new RAM module to check if it solves the problem: 4GB Kingston HyperX Impact HX316LS9IB/4 - 1600MHZ DDR3L CL9 SODIMM But unfortunately the problem still exists (Loop after switch on). Even with ME_RST and RTC_RST. :cry: are there ot...

Hi, I was working with my new IPC2 for two days and my screen was starting flickering. After some tests with drivers I thougt I should try a new BIOS. OK, I have Windows8.1 installed and I was not able to boot into the BIOS because Windows 8.1 does not completely shuts down. I thougt I should remove...