Done. But problem still exists.1. Press ME_RST for 3 sec
2. Press RTC_RST for 3 sec
Search found 5 matches
- Mon Sep 22, 2014 9:05 am
- Forum: IPC2 faults and troubleshooting
- Topic: IPC2 not working anymore
- Replies: 9
- Views: 19118
Re: IPC2 not working anymore
- Sun Sep 21, 2014 3:59 pm
- Forum: IPC2 faults and troubleshooting
- Topic: IPC2 not working anymore
- Replies: 9
- Views: 19118
Re: IPC2 not working anymore
Unfortunately there is still a loop with harddisk in. I think the BIOS is still in the configuration state of windows fast boot. All I want is to reset the board to factory defaults. But the RTC_RST does not change these settings. I read about similar problems on other hardware. A solution might be ...
- Thu Sep 18, 2014 10:49 pm
- Forum: IPC2 faults and troubleshooting
- Topic: IPC2 not working anymore
- Replies: 9
- Views: 19118
Re: IPC2 not working anymore
Dear hwmartin, thanks again. Here my answers: Again, I would recommend that you install the memory that shipped with the IPC2 and try the instructions on CompuLab's IPC2 troubleshooting page. I bought the IPC2 without memory and HD. I have tried all troubleshooting steps on the troubleshooting page ...
- Wed Sep 17, 2014 6:28 pm
- Forum: IPC2 faults and troubleshooting
- Topic: IPC2 not working anymore
- Replies: 9
- Views: 19118
Re: IPC2 not working anymore
Dear hwmartin, Thanks a lot for your feedback. Yesterday I bought a new RAM module to check if it solves the problem: 4GB Kingston HyperX Impact HX316LS9IB/4 - 1600MHZ DDR3L CL9 SODIMM But unfortunately the problem still exists (Loop after switch on). Even with ME_RST and RTC_RST. :cry: are there ot...
- Thu Sep 11, 2014 6:55 pm
- Forum: IPC2 faults and troubleshooting
- Topic: IPC2 not working anymore
- Replies: 9
- Views: 19118
IPC2 not working anymore
Hi, I was working with my new IPC2 for two days and my screen was starting flickering. After some tests with drivers I thougt I should try a new BIOS. OK, I have Windows8.1 installed and I was not able to boot into the BIOS because Windows 8.1 does not completely shuts down. I thougt I should remove...