Search found 5 matches

by parsifal9
Fri Feb 28, 2020 3:51 am
Forum: fit-PC4 faults and troubleshooting
Topic: only 2 of 6 USB2.0 ports work after recovery from suspend
Replies: 5
Views: 16192

Re: only 2 of 6 USB2.0 ports work after recovery from suspen

Hi tamir and Forum, That is all correct, except 5.1. I move the mouse to a working USB port, suspend and then neither mouse or KB are working. However it seems to depend on which USB port is used and which port the mouse is moved to etc. I can not figure out what is happening. I have recorded which ...
by parsifal9
Sun Feb 23, 2020 10:43 am
Forum: fit-PC4 faults and troubleshooting
Topic: only 2 of 6 USB2.0 ports work after recovery from suspend
Replies: 5
Views: 16192

Re: only 2 of 6 USB2.0 ports work after recovery from suspen

Hi tamir and Forum, I have upgraded my system from Mint 19.0 to 19.3. The problem persists. However, I don't think that my initial report was accurate. 1) I loaded every USB with a thumb drive. The "lsusb" output is below 2) suspended the machine and then checked "lsusb" again. All the thumb drive a...
by parsifal9
Thu Feb 20, 2020 12:10 pm
Forum: fit-PC4 faults and troubleshooting
Topic: only 2 of 6 USB2.0 ports work after recovery from suspend
Replies: 5
Views: 16192

only 2 of 6 USB2.0 ports work after recovery from suspend

Hi all, the heading pretty well says it all. When the fitpc4 comes back from a power "suspend" only 2 USB2.0 ports work (one on the front and one on the rear). The USB3.0 ports both work. I tried various GRUB_CMDLINE_LINUX_DEFAULT options before concluding that these were unlikely to have anything t...
by parsifal9
Tue Feb 11, 2020 7:12 am
Forum: Storage
Topic: disk failure - cable problem?
Replies: 3
Views: 10585

Re: disk failure - cable problem?

Hi Tamir, thanks for that. I think that this repair is not something I can do. I bought the machine in another country at least 8 years ago. So sending it back to the supplier is not really on the cards. The Displayport output has also failed (a while ago) so I am using the hdmi. I use the machine a...
by parsifal9
Mon Feb 10, 2020 12:16 am
Forum: Storage
Topic: disk failure - cable problem?
Replies: 3
Views: 10585

disk failure - cable problem?

Hi Forum, I had a disk failure on a fitpc3. The machine would not boot at all and I got errors like "ata1.00 device reported invalid CHS sector 0" when I got into rescue mode. I replaced the disk and installed an operating system. However, I am still getting error messages. I have looked around on s...

Go to advanced search